Kenmore 141.173373 - Manual (Page 16)

Installing The G rill Head Figure 6a (LP gas m odel only)
1. Now that you've assembled the grill cart you
can install the pre-assembled Grill Head. See
Figure 6a or 6b. If you haven't already done
so, we suggest you open the Grill Lid and
remove the packed components. Even with the
components removed, this next step requires
2
people.
BE CAREFUL NOT TO PINCH FINGERS
WHEN LOWERING HEAD ONTO CART
2. For LP Gas grills:
With an assistant, lift and position the Grill
Head onto the grill cart. Place the Side Burner
Gas Valve Assembly through the ^ot in side of
Grill Head as illustrated in Figure 6a. Align the
4 holes of the Bowl Side Panel to the
threaded holes on the Cart Leg Bracket.
Thread the Electric Wire into the Wire Fastener.
Secure Wire Fastenerto Right Rear Bowl location on
Grill Head using 1 of the 1/4"x1/2" Pattern Head
Screw. Finish securing Grill Head to Cart using 3 of
the 1/4"x1/2" Pattern Head Screws provided.
3. For Natural Gas grills:
With an assistant, lift and position the Grill
Head onto the grill cart. Place the Side Burner
Gas Valve Assembly and Electric Wire through
the slot in side of Grill Head as illustrated in
Figure 6b. Align the 4 holes of the Bowl Side
Panel to the threaded holes on the Cart Leg
Bracket. Secure firmly by using 4 of the 1/4"x
1/2" Pattern Head Screws provided.
jlnstalling Lighting Stick
Attach the Lighting Stick to the Left B o \ a ^
Support Bracket as shown in Figure 7.
Align the hole at the end of Lighting Stick
Wire with the threaded hole on the Left Bow^
Support Bracket. Tighten securely using the
M4x8mm Pattern Head Screw.
Figure 6b (Natural gas model only)
Figure 7
16