For natural gas grills, Assembly tips, Figure 8f – Kenmore 141.173373 User Manual
Page 18
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
6. For Natural Gas grills;
Connect the Electric Wire terminal from Side Burner
with the other from Grill Head. See Figure 8d. Bind
the connected Electric Wires, and Connection Tube
together uang the supplied Fastening Band.
7. The gap between the Side Burner Electrode Tip and
the Side Burner Port should be approximately
1/8"~3/16". See Figure 8e. If the gap is wider than
3/16", use a pair of long nose pliers and gently
bend the Electrode Tip toward the Burner.
8. Slide the 5 Tool Hooks onto the Tool Holder wth
hooks facing the grill Head. Attach Tool Holder
to left side of Side Shelf and secure firmly uang
2 of the M5x8mm Pattern Head Screws and
washers supplied. See Figure 8f.
Assembly Tips
When you have finished assembiing your
grill we strongly urge that ail Pattern
Head Thumb Screws be tightened, either
with the supplied Tightening Tool or a
#2 Phillips Head Screwdriver.
Tightening Tool
Ref. # P05515102K
Figure 8d (Natural G as m odel only)
9. For Natural Gas grills:
Connect the hose end of the 12' Natural Gas
Hose to the vertical fitting as shown in Figure
8g. Also read the natural gas safety instruc
tions. (on page 4)
Figure 8g (Natural gas model only)
Figure 8e
1
/
8
"-
3
/
16
"
BURNER
Figure 8f
TOOL HOOK
18