Kenmore 141.173373 - Manual (Page 15)

^ Installing The Cabinet Doors
For Natural Gas grills:
1. Install the Door Stops to the Cart Bottom
Shelf and the Door Bracket. See Figure 5a.
2. Align the holes on the Door Stops with the
threaded holes on the top of the Cart Bottom
Shelf and ixittom side of Door Bracket. Tighten
securely uang 4 of the 1/4''x1/2” Pattern Head
Screws provided. See Figure 5a.
3. Remove the white protective film from the
stainless steel Doors. Attach a Door Handle to
each Door using 2 of the M4x5mm Pattern
Head Screws provided. See Figure 5b. Be
careful not to scratch the Door surfaces.
4. When installing the Doors, make sure the
door bolt holes are located on the hinge sides
of the Cart Legs.
5. Install either Door by inserting 1/4"x5/8" partly-
threaded bolt through the lower door bolt hole
of the Door and into the tapped hole of the
Cart Bottom Shelf. Next, align the upper door
bolt hole of Door with the tapped hole in the
bottom of Door Bracket. Insert 1/4"x1/2" partly-
threaded bolt provided. Tighten both bolts
securely.
6 . Repeat these steps to install the other Door.
7. Install the Cart Spice Ba^et to the inside of Left
Door. Align the threaded holes on the inade of Left
Door with the holes on the Cart Spice Basket.
Tighten securely using 2 of the 1/4"x1/2" Pattern
Head Screws provided. See Figure 5b.
8 . Install the Cart Spice Basket to the inside of Right
Door. Align the threaded holes on the inside of Right
Door with the holes on the Cart Spice Basket.
Tighten securely using 2 of the 1/4"x1/2" Pattern
Head Screws provided. See Figure 5b.
Assembly Tips
When you have finished assembling your
grill we strongly urge that all Pattern
Head Thumb Screws be tightened, either
with the supplied Tightening Tool or a
#2 Phillips Head Screwdriver.
Figure 5a (NG gas m odel only)
Tightening Tool
Ref. # P05515102K
Figure 5b (NG gas model only)
DOOR
BRACKET
15