Kenmore 141.173373 - Manual (Page 13)

Assembly Instructions
CAUTION: While it is possible for one person to
assembie this grill, obtain assistance from another
person when handling some of the larger, heavier
pieces, especially the grill head.
Figure 1
During unpacking and assembly always wear work
oves and eye protection.
1
.
glo . ,
2. Open Lid of shipping carton and remove top sheet
of cardboard. Lay cardboard sheet on floor and
use as a work surface to protect floor and grill parts
from scratches.
3 . Slice ail carton corners with a sharp utility knife to
lay open the carton panels.
4. Remove all packing materials and parts boxes
flanking or resting on grill head.
5. Remove all components packed inside grill head.
6 . With an assistant, lift the grill head away from the
shipping carton and place it on the cardboard work
surface. Be careful not to set grill head down on
flexible metal hose of the pre-assembled valve kit
or you may damage the hose.
7. Use the parts list to check that all parts have been
included.
8 . Inspect the grill for damage as you assemble.
Do not assemble or operate the griil if it appears
damaged. If there are damaged or missing parts
when you unpack the shipping box. or if you have
questions during the assembly process, call:
1-888-317-7642 8am-8pm CST, Mon-Fri
Q Assembling The Grill Cart
NOTE: To aid in assembly, compare hardware to
diagrams on page 7 and page 9.
1. Before attaching the Cart Bottom Shelf to the
Cart Legs be sure the holes for the Door Stop
on Cart Bottom Shelf are located on the front
side. Be sure the Cart Leg Brackets and air
vents all face outward. Rimt Cart Leg Bracket
has a semi-circle cutout at top front.
See Figure 1.
2
.
3.
4.
Install the Cart Bottom Shelf between the Cart
Legs. Align the holes on Cart Legs with the
threaded holes at the corners of Cart Bottom
Shelf. Tighten securely using 8 of the 1/4"x2"
Pattern Head Screws provided. See Figure 1.
Screw the 2 Casters into the Caster Seats (see
bottom of Cart Legs). Turn the threaded Caster
Stem by hand, clockwise until it stops. Tighten
securely using the Customized Wrench provided.
See Figure 1.
1
.
Install the 2 Wheels to the Right Cart Legs, b'
inserting the Wheel Bolt through the Wheel anc
axle hdie on the Cart Leg as showt in
Put spring washer and 3/8" nut onto.....................
tighten securely using the Customized Wrench
provided. Do not overtighten or \Aheel will not
turn freely. Snap Wheel Hub Caps onto Wheels.
Figure
bolt and
5. For LP Gas grills:
Place the Tank Pull-out Trw Assembly on the Cart
Bottom Shelf. Extend the Tank Tray outward from
the Bracket so you can align the holes on the
Bracket with the threaded holes on the top of Cart
Bottom Shelf. Tighten securely using 4 of the 1/4"x1/
2" Pattern Head Screws provided. See Figure 2.
6 Install the Cart Rear Panel to inside of rear Cart
Legs making sure that air vents face outward.
Align the holes on the Cart Rear Panel with the
threaded holes on rear Cart Legs. Tighten
securely using 4 of the 1/4"x1/2" Pattern Head
Screws provided. See Figure 3.
CART LEG
Figure 2 (LP gas model only)
LEFT CART LEG
Figure 3
13