beautypg.com

To operate the single surface elements, Operating the dual surface radiant element, To operate the dual surface element – Kenmore ELITE 790.467 User Manual

Page 9: Ik caution, A caution, Setting surface controls (confd), Operating single radiant surface elements

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

background image

Right Rear Element

Operating Single Radiant Surface Elements

The cooktop has single radiant surface elements at 2
locations; the right rear (Figure 1) and left rear (Figure 2)
element positions.

To Operate the Single Surface Elements:

1. Place correctly sized cookware on the radiant surface

element.

2. Push in and turn the surface control knob in either

direction to the desired setting (Figure 3). Turn the knob
to adjust the setting if desired. Start most cooking operations on a higher setting and
then turn to a lower setting to finish cooking. Each surface element provides a
constant amount of heat at each setting. A glowing red surface heating area extending

beyond the bottom edge of the cookware indicates the cookware is too small for the
surface heating area.

3. When cooking has completed, turn the surface control knob to OFF before removing

the cookware. Note: The Hot Surface Indicator light located on the cooktop glass will
come on when the glass becomes hot and will continue to glow until the glass has
cooled down to a moderate level. The light may remain on even though the controls
are turned OFF.

Note: See page 8, Figure 3 for recommended control settings.

Operating the Dual Surface Radiant Element

The cooktop is equipped with a dual radiant surface element
located at the right and left front (See Figure 4) positions.

# and ^ on the control panel are used to indicate which

coil of the dual radiant element will heat.

%

indicates that

only the inner coil will heat (Figure 4). @ indicates that both

inner and outer coils will heat (Figure 5). You may switch
from either coil setting at any time during cooking.

To Operate the Dual Surface Element:

1

Setting Surface Controls (confd)

Figure 2

Left Rear Element

O

ff

M

ed

Figure 3

O

ff

O

ff

• H

i

2

.

3.

Place correctly sized cookware on the dual surface
element.
Push in and turn the control knob to left side (See
Figure 6) for smaller cookware and to right side (See
Figure?) for larger cookware.

Turn the knob to adjust the setting if needed. Start most
cooking operations on a highersetting and then turn to a lower

setting to finish cooking. Each surface element provides a

constant amount of heat at each setting. A glowing red

surface heating area extending beyond the bottom edgeofthe

cookware indicates the cookware is toosmallforthe surface

heating area.

4. When cooking has completed, turn the surface control knob to OFF before removing the cookware. Note: The

Surface Indicator light will come on when the control knob is turned on and will continue to glow until the glass

cooktop has cooled down to a moderate level. The light may remain on even though the controls are turned OFF.

Note: See page 8, for recommended control settings.

HI®

Figure 6

Lo

Figure 7

ik CAUTION

I

Radiant surface elements may appear to have cooled after they have been turned off. A hot surface indicator

light will come on and will continue to glow until the glass cooktop has cooled down to a moderate level. The glass surface may
still be hot and burns may occur If the glass surface is touched before the indicator light has turned off.

A CAUTION

I Do not place plastic items such as salt and pepper shakers, spoon holders or plastic wrappings on

top of the range when it is in use. These items could melt or ignite. Potholders, towels or wooden spoons could catch
fire if placed too close to the surface elements.

9