Kenmore ELITE 790.467 - Manual (Page 13)

To Set the Cooktop Lockout Feature 0
C ooktop
The clock (^) pad is used to activate the Cooktop Lockout feature which will lock all surface elements from being
accidentally turned ON. This feature will only lock the cooktop.
INSTRUCTIONS PRESS DISPLAY
Setting Surface Controls (confd)
To turn the Cooktop Lockout Feature ON:
1. BE SURE ALL surface element controls are set to the OFF position.
2. Press and hold (^) until "CLO" appears (Figure 1). Continue holding
until a second beep sounds (after 3 seconds). If a triple beep sounds
instead, check all surface elements and turn them to the OFF position
and repeat this step. Q will appear in the display indicating the cooktop
controls and functions are locked out until the cooktop is unlocked (See
Figure 2).
To turn the Cooktop Lockout Feature OFF:
1. BE SURE ALL surface element controls are set to the OFF position.
2. Press and hold (^) until "CLO" appears. Continue holding until a
second beep sounds (after 3 seconds). If a triple beep sounds
instead, check all surface elements and turn them to the OFF
position and repeat this step. Q will disappear from the display
indicating the cooktop may be used normally (See Figure 3).
on r » n
I j U l l u
Figure 1
Figure 2
Figures
Note: Starting a Self-Clean cycle will automatically turn ON the Cooktop Lockout feature. The cooktop will remain locked
until the Self-Clean cycle has completed and the oven door has unlocked. If a power failure occurs after the Cooktop
Lockout has been activated, you must turn OFF the Cooktop Lockout feature before being able to use the cooktop
features again.
ill
2i;
o
C
: ■
13