General care & cleaning (confd), To remove warmer drawer, To replace warmer (warm & ready™) drawer – Kenmore ELITE 790.467 User Manual
Page 41: Changing the oven light, Caution: be sure the oven is cool, Halogen light bulb, General care & cleaning -43
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
General Care & Cleaning (confd)
Removing and Replacing Warmer (Warm & Ready'^'^) Drawer
ik WARNING
j Electrical Shock Hazard can occur and result
in serious injury or death. Disconnect appliance from electric
power before cleaning and servicing the warmerdrawer.
To Remove Warmer Drawer:
A CAUTION
[Turn power off before removing the warmer
drawer.
2. Open the drawer to the fully opened position.
3. Locate glide lever on each side of drawer, pull up on the left
glide lever and push down on the right glide lever (See Figure 1).
4. Pull the drawer away from the range.
To Replace Warmer (Warm & Ready™) Drawer:
1. Pull the plastic slider to the front of the glide slots on each
side of the drawer cavity (See Figure 2).
2. Align the glide on each side of the drawer with the drawer cavity
glide slot.
3. Push the drawer into the drawer cavity until glide levers “click”
(approximately 2”). if you do not hear the glide levers “click”
or the drawer does not feel seated remove the drawer and
repeat steps 1 thru 3.
Note: The Warmer Drawer will NOT operate while in the “Self-Clean”
and “Oven Lockout” modes
Pull down lever
with finger
Right Glide
Figure 1
Changing the Oven Light
The oven lights will automatically turn ON when the oven door is opened. The
oven lights may also be manually operated by pressing the pad.
The oven light bulb is covered with a glass shield. The glass shield can be
removed to be cleaned manually or to change oven light. THIS GLASS SHIELD
MUST BE IN PLACE WHENEVER THE OVEN IS IN USE.
To replace the light bulb:
CAUTION: BE SURE THE OVEN IS COOL.
and remove it.
1
.
2
.
3.
4.
5.
Turn the power off at the main source.
Wear a leather-faced glove for protection against possible broken glass.
To remove the glass shield, lift up on side with gloved finger and use force
to pull shield out.
Replace halogen light appliance bulb taking care not to touch the bulb with
your bare fingers. Touching bulb with your skin can leave a film on the bulb
that causes it to burn out quickly.
Replace glass shield in opposite order and manner of removal.
Halogen
Light Bulb
41