Setting oven controls, Setting the clock, To set the clock (example below for 1:30) – Kenmore ELITE 790.467 User Manual
Page 15: Changing between 12 or 24 hour time of day display, Ic-uu “r, 3u ll u, Setting surface controls -13, Nn pc
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Setting Oven Controls
Setting the Clock
The (^) pad is used to set the clock. The clock may be set for 12 or 24 hour time of day
operation. The clock has been preset at the factory for the 12 hour operation. When the
range is first plugged in, or when the power supply to the range has been interrupted, the
timer in the display will flash with "PF" (power failure, See Figure 1).
PRESS
When PF appears in the display, press PF will disappear.
INSTRUCTIONS
To set the clock (example below for 1:30)
1. Press (^). "CLO" will appear in the display (Figure 2).
2. Press
pads to set the time of day to 1:30
(Figure 3). "CLO” will stay in the display. Press <
start
'>. "CLO"
will disappear and the clock will start (Figure 4).
Changing between 12 or 24 hour time of day display
1. Press and hold (^) for 7 seconds. "CLO" will appear in the
display. After 3 seconds Q will appear in the display indicating
that the cooktop lockout is active (Figure 5). CONTINUE holding
the pad until "12h" (Figure 6) or "24h" (Figure 7) appears in the
display and the control beeps once.
2. Press to switch between the 12 and 24 hour time of day
display. The display will show either "12h" (Figures) or "24h"
(Figure 7).
3. Press .START to accept the change or press (s^ to reject the
change. Q will disappear from the display.
4. Reset the correct time as described in To set the Clock above.
Please note that if the 24 hour time of day mode was chosen,
the clock will now display time from 0:00 through 23:59 hours.
(D(D®
START
for 7 seconds
<
star
(>or
{STOP
l
3
-nn pc
IC-UU “r
Figure 1
DISPLAY
tj n n r t rt
IC UU Ltu
Figure 2
□n r» n
3U LL U
Figures
Figures
Figure 7
15