Cabletron Systems 150 User Manual
Page 53
Small Office Remote Access Switch 53
IP R
OUTING
N
ETWORK
WITH
R
EMOTE
B
RIDGE
D
EVICES
Configure the CyberSWITCH
You will then be prompted to verify your input. Make changes if necessary, or, if original input
correct, continue with configuration for RLAN interface.
Press 1 to add the next interface. Configure the information for the WAN (RLAN) interface as
follows:
1) LAN
2) WAN
3) WAN (Direct Host)
4) WAN (RLAN)
5) WAN (UnNumbered)
Select Option or press
INTERFACE NAME or
Enter the IP Address in dotted decimal notation
or
Enter the number of significant bits for the Subnet Mask
[default = 16]?
Enter the packet encapsulation type 1) for ETHERNET 2) for SNAP
[default = ETHERNET]?
Enter the MTU size in bytes [default = 1500]?
Transmit Broadcast Address:
1) 128.1.255.255
2) 128.1.0.0
3) 255.255.255.255
4) 0.0.0.0
5) Specify Explicitly
Enter a Transmit Broadcast Address [default = 1]:
RIP Send Control:
1) Do Not Send.
2) RIP Version 1.
3) RIP Version 1 Compatibility.
4) RIP Version 2.
Enter RIP Send Control [default = 2]:
RIP Receive Control:
1) Do Not Receive.
2) RIP Version 1 Only.
3) RIP Version 2 Only.
4) RIP Version 1 or Version 2.
Enter RIP Receive Control [default = 4]:
RIP Respond Control:
1) Do Not Respond.
2) RIP Version 1 Only.
3) RIP Version 2 Only.
4) RIP Version 1 or Version 2.
Enter RIP Respond Control [default = 4]:
RIP Version 2 Authentication Control:
1) No Authentication.
2) Simple Password.
Enter a RIP Authentication Control [default = 1]: