Cabletron Systems 150 - Manual (Page 105)

Small Office Remote Access Switch 105
A PPLE T ALK R OUTING N ETWORK
Verify the Installation
• next hop’s device name
Whenever you enter 0.0 for the next hop address, you are then required to enter the next hop’s
device name. Enter SITE2.
• number of hops
This is the number of devices between the device you are configuring and the network across
the WAN. In this case, there is one site, SITE2, between SITE1 and the network across the WAN.
Enter 1 for the number of hops.
• default zone name
To enter the zone names associated with SITE2’s LAN segment, first enter SITE2.Engineering as
the default zone name, then add SITE2.Marketing as a second zone name.
Return to the main CFGEDIT menu.
S AVE C ONFIGURATION F ILES
We have now configured all required information for this example. Select Save Changes from the
main CFGEDIT menu. Follow the on-screen instructions to save any configuration changes made.
The old configuration files will be stored in the \CONFIG directory with a file extension of .BAK
(e.g., the old NODE.NEI file will be called NODE.BAK).
After saving the configuration files, press to exit the CFGEDIT program. Reboot the system
to activate your changes.
V ERIFY THE I NSTALLATION
Steps on how to verify the installation are detailed in the System Verification chapter of the User’s
Guide. This section gives an outline of which steps should be executed.
On the CyberSWITCH:
Verify hardware resources are operational
Issue dr command
Look for BRI messages
Look for LAN initialized messages
Verify WAN Lines Available
Connect WAN lines
Issue
dr command
Look for “Data Link up 1,1” in reports
On each AppleTalk LAN:
Attempt accessing a resource on the CyberSWITCH LAN. This may require that you reboot
your system and proceed through the logon sequence.