Cabletron Systems 150 - Manual (Page 44)

EXAMPLE NETWORKS
44 CyberSWITCH
V
ERIFY THE
I
NSTALLATION
Steps on how to verify the installation are detailed in the System Verification chapter of the User’s
Guide. This section gives an outline of which steps should be executed for Example 3.
On the CyberSWITCH:
Verify hardware resources are operational
Issue dr command
Look for BRI line messages
Look for LAN initialized messages
Check for IP routing initialized message in log
Verify WAN Lines Available
Connect WAN lines
Issue
dr command
Look for “Data Link up 1,1” in reports
On each Remote Host:
•
Attempt to access a resource on the CyberSWITCH LAN. This may require that you reboot
your system and proceed through the logon sequence.
• Have the remote hosts ping the CyberSWITCH.
• Have the CyberSWITCH ping the remote hosts (if a connection is up).