beautypg.com

Needle and thread table, Placement of needle, Needle size – Kenmore 1206 User Manual

Page 6

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

background image

NEEDLE AND THREAD TABLE

THREAD SIZE

NEEDLE

SIZE

fabric

Cotton 60—100
Synthetic
Silk A

11

Sheer cottons, silks, and synthetics

Fine Laces

Cotton 60—80
Mercerized 50
Synthetic
Silk A

14

Medium weight cottons

Medium weight silks
Medium weight synthetics

Light weight woolens

Cotton 40—60
Mercerized 50
Mercerized heavy duty

16

Heavy weight cottons
Medium to heavy weight woolens

Heavy drapery fabrics

Cotton 30—50
Mercerized heavy duty

18

Heaviest cottons as for men's work clothes

Heaviest woolen coating

NEEDLE SIZE

Use KENMORE needles. The size of the needle should conform to the size
of the thread and both should be suitable to the material

The same size thread should be used in the bobbin as on the upper part of the
machine for ordinary sewing.

Never use a bent needle nor one with a blunt point.

This is the exact length of the needle to

be used in your machine. Comparison

with

this

illustration

will

determine

whether the needle you have is the cor­
rect one for your machine.

PLACEMENT OF NEEDLE

Raise take-up lever to its highest position
by turning hand wheel toward you.
Loosen needle clamp screw.

Hold needle so that the flat side is to your
right, slip blunt end of needle as far as n
will go into needle clamp.
Tighten needle into place with clamp
screw.

This manual is related to the following products: