Darning, Pmssm, Without – Kenmore 1206 User Manual
Page 21
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
DARNING
WITH PRESSER FOOT;
1. Turn feed dog control to left.
2. Press down outer ring of presser foot pressure regulator, see page 10. With regulator in this posi
tion mending, monogram work, etc. may be done.
3. Stretch fabnc tightly between two spring embroidery hoops and place under needle.
The presser bar can be raised to accommodate the embroidery hoop by pulling up on the presser
foot lever.
4. Lower presser bar so thread will have some tension. When you start to dam, move fabnc back and
forth to cover darning area. Then turn fabric and continue sewing at right-angles to the previous
stitching. Always use medium machine speed. You can make any length stitches dfesired. Slow
movement of fabric will make short darning stitches. Fast movement will make long stitches.
5. When you finish darning, raise presser foot and remove fabric. Increase pressure for general sewing
by pressing center pin of presser foot pressure regulator.
Turn feed dog control to right.
20
WITHOUT
pmssm
footj
1. Turn feed dog control to left.
2. Remove presser foot.
Proceed as directed under steps 3 and 4 above.
5. When you finish darning, raise the presser bar and remove fabric. Replace presser foot.
Turn feed dog control to right.