beautypg.com

How to delay the start of cleaning, After a clean cycle, Care and cleaning of the range – GE CGS975SEDSS User Manual

Page 32

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

background image

Care and cleaning of the range.

The oven door must be closed and all controls set correctly for the cycle to work properly.

S

elf

C

lean

[ 2 i n [ 2 0 S

S

et

UttRMwe O

mh

«

0 0 H 0 0

C

ontmi

loanin'

D

elay

S

tart

0

[2000

V

akhing

O

mhcr

0

0

0

0

S

tart

How to Delay the Start of Cleaning

Make sure the clock shows the correct time of

day.

On models with

Gas/Control Lockout,

touch and hold the

Gas/Control Lockout

pad for 3 seconds to turn it off.

NOTE: The surface burners must be turned off
prior to the self-clean start time.

If your model has a latch, latch the door.

Touch the

Self Clean

pad.

Using the number pads, enter the desired

clean time.

Touch the

Delay Start

pad. The earliest

start time you can set will appear in the
display.

Using the number pads, enter the time of

day you want the clean cycle to start.

^ Touch the

Start

pod.

On models without a door latch, the door locks
automatically. The display will show the start

time. It will not be possible to open the oven

door until the temperature drops below the
lock temperature and the

LOCKED DOOR

light

goes off.

d

The oven shuts off automatically when the

clean cycle is complete.

When the

LOCKED DOOR

light is off, slide

the latch handle to the left as far as it will

go and open the door. If your range does
not have a latch, the door will unlock
automatically.

I The words

LOCK DOOR

will flash and the

oven control will signal if you set the clean
cycle and forget to close the oven door or

forget to latch the door on models with a

latch.

I To stop a clean cycle, touch the

Clear/Off

pad. When the

LOCKED DOOR

light goes

off, indicating the oven has cooled below the
locking temperature, unlatch the door (on
models with a latch) and open the door.

After a Clean Cycle

You may notice some white ash in the oven.
Wipe it up with a damp cloth after the oven
cools.

If white spots remain, remove them with a

soap-filled scouring pad and rinse thoroughly

with a vinegar and water mixture.

These deposits are usually a salt residue that

cannot be removed by the clean cycle.

If the oven is not clean after one clean cycle,
repeat the cycle.

I You cannot set the oven for cooking until the

oven is cool enough for the door to unlock.

I While the oven is self-cleaning, you can

touch the

Clock

pad to display the time

of day. To return to the clean countdown,

touch the

Cooking Time

pad.

I If the shelves become hard to slide, apply a

small amount of vegetable oil or cooking oil to
a paper towel and wipe the edges of the oven
shelves with the paper towel.

32

This manual is related to the following products: