beautypg.com

Before a clean cycle, Using the self-cleaning upper oven – GE CGS975SEDSS User Manual

Page 31

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

background image

Using the self-cleaning upper oven.

GEAppliances.com

if your model has a door latch, never farce the latch handle. Farcing the handle will damage the daar lack mechanism.

The oven door must be closed and all controls set correctly for the cycle to work properly.

Before a Clean Cycle

Wipe up heavy soil on the oven

bottom.

DO NOT

hand

clean gasket. lOn

some models,

DO

hand clean

inside door Ararne

For the first self-clean cycle, we recommend

venting your kitchen with an open window or

using a ventilation fan or hood.

Remove any broiler pan, broiler grid, all

cookware, probe and any aluminum foil from

the oven—they cannot withstand the high

cleaning temperatures.

NOTE:
■ If your oven is equipped with nickel oven

shelves, remove them before you begin the
self-clean cycle.

■ If your oven is equipped with gray

porcelain-coated oven shelves, they may be
left in the oven during the self-clean cycle.

Soil on the front frame of the range and

outside the gasket on the front frame will

need to be cleaned by hand. Clean these

areas with hot water, soap-filled scouring

pads or cleansers such as Soft Scrub«: Rinse

well with clean water and dry. Wipe off the

flat inner door and glass with soapy water

and sponge.

Do not clean the gasket. The fiberglass
material of the front frame gasket cannot

withstand abrasion. It is essential for the
gasket to remain intact. If you notice it

becoming worn or frayed, replace it.

Wipe up any heavy spillovers on the oven

bottom.

Make sure the oven light bulb cover is in place

and the oven light is off.

IMPORTANT:

The health of some birds is

extremely sensitive to the fumes given off
during the self-cleaning cycle of any range.

Move birds to another well ventilated room.

NOTE: Use caution when opening the upper
oven after the self-clean cycle has ended. The
oven may still be hot.

S

elf

C

lean

Ser IV

mmwm

O

mhcr

H 0 H H H

S

tart

Using the number pads, enter the desired

clean time, if a time other than 4 hours is
needed.

Clean cycle time is normally 4 hours. You can
change the clean time to any time between
3 hours and 5 hours, depending on how dirty

your oven is.

Touch the Sfort’ pad.

How to Set the Upper Oven for Cleaning

gj On models with Gas/Control Lockout,

touch and hold the

Gas/Control Lockout

pad for 3 seconds to turn it off.

NOTE: The surface burners must be turned off

prior to the self-clean start time.

If your model has a latch, latch the door.

Touch the

Self Clean

pad.

The oven shuts off automatically when the

clean cycle is complete.

When the

LOCKED DOOR

light is off, slide

the latch handle to the left as far as it will

go and open the door. If your range does
not have a latch, the door will unlock
automatically.

On models without a door latch, the door locks
automatically. The display will show the clean

time remaining. It will not be possible to open
the oven door until the temperature drops

below the lock temperature and the

LOCKED

DOOR

light goes o1^.

I The words

LOCK DOOR

will flash and the

oven control will signal if you set the clean
cycle and forget to close the oven door or

forget to latch the door on models with a

latch.

I To stop a clean cycle, touch the

Clear/Off

pad. When the

LOCKED DOOR

light goes

off, indicating the oven has cooled below

the locking temperature, unlatch the door
(on models with a latch) and open the door.

31

This manual is related to the following products: