Convert thiovih burner orifices, S convert air, Shuner(s) – GE 49-8338 User Manual

Page 45: Check for le«k, Adjustment, Imqt'a ¥ ¥ at'¥rim ¥mji2*ti^¥tr^'t’frume

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

IMQT'A ¥ ¥ AT'¥riM ¥mJI2*Ti^¥Tr^'T’frUMe

M X - % K ^ -B-iHR a .^,a JiriLJSL:M.S^X ^‘ :JSL±'%k^ M.

JL Ji.^l'^tjy

(continued)

HOW TO COMVERT THE RAHOE FOR USE

WITH IP

OR HATURAL GAS (continued)

CONVERT THIOVIH BURNER ORIFICES

@¥©il iyr^@r

1. Remove oven door, storage drawer or broiler

drawer, oven bottom and burner baffle. Tne

lower burner orifice spud is located behind the
storage drawer, broiler drawer or kick panel, (On
some models, a metal shield must be removed to
access the orifice.)

2. To convert to IP gas,
use a

1/2"

wrench to turn

the lower burner orifice

spud clockwise. Tighten the

^ud only until it is snug.

prevent damage, do

not overtighten the spud.

To convert to natural gas,

loosen the spud about 2 turns.

§r®il iureier (on some models)

To convert to IP gas, use a 1/2" wrench to

turn the upper burner orifice spud clockwise.

Tighten spud only until it is snug with the base.
To prevent damage, do not overtighten spud.

To convert to natural gas, loosen the spud

iiKmil

fiirnc

S CONVERT AIR

adjustment

SHUnER(S)

For IP gas, loosen the

__ _ 1______ I _________ __ J

niimps ucciu si;i cw cum

rotate the shutter to the

full open position. With
baffle in place, flames

should have approximately

uxuc:; V/Vxii^o cuxui

should not extend beyond

the edges of the burner baffle. After 30 seconds
of burner operation, check for flames lifting off

burner ports. If lifting is observed, graduaUy

r#»r

iir*A air

nr»i»ninrr iinfil fla-miio at*«

VAJH

V/jpV'XXUlA^ V4XXLXX XJ.«

AXXX>^0 CXX V..'

stabilized.

For natural gas, the shutter should be open

1/2" or about 3/4 of the way open.

CHECK FOR LE«K

When all connections have been made, make sure

all range controls are in the off position and turn
on the main gas supply valve. Use a Uquid leak
detector at all joints and connections to check for

leaks in the system.

CAUnONi DO NOT USE A FlAiVlE TO
CHECK FOR GAS LEAKS.

When using test pressures greater than 1/2 psig

to pressure test the gas supply system of the
residence, disconnect the range and individual
shut-off valve from the gas supply piping. When
using test pressures of 1/2 psig or less to test the

gas supply system, simply isolate the range from
the gas supply system by closing the individual

^££_1_

sjiuL-uii vcuve.