S .‘7q>c cf n 7, Clock and timer, To set the clock – GE 49-8338 User Manual
Page 11: To set the timer, Io change or cancel the timer setting, To display the clock while the timer is operating, This model has an improved clock. aiodei-s, S-q
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
'
This model has an improved clock.
AiodEi-s:
Oru~Y
Please use this sheet in place of the instructions
in your Use and Care Guide.
>’S-Q
Pi^
^£>'S .‘7q>c cf
n 7
'
'
'
CLOCK AND TIMER
Follow ihe directions below if your range has the
dock and timer shown at the right.
H
j
C range clock and timer allow you to set the tuner
up
10
24 hours. You have the choice of having the
timer .sliow the lime counting down or the time of day.
In ciihcr case, the timer will signal at die end of the
timer period lo alen you ihai ihc lime is up.
CLOCK j
TIMER
f _# • f
i f i
' U L J
(Appearance may vary)
To Set the Clock
NO i K: Wlicn you first piug in the range or after a
power
lailure, ilie entire Cloek/Timer display will
!iu!u up= Aficr scvcni! .seconds ”SET CLOCK *
appears in the display.
1. Press the CLOCK pad.
2. Press and hold Ihe UP or DOWN pad and the lime
of day will change 10 minutes at a time. To change
the lime by single minutes, give the pads short laps.
3
. Prc.ss Ihc CLOCK nnd to start the eloek-
To Set the Timer
1. Press the TIMER pad.
2. Use the UP and DOWN pads to set the timer
Short taps on the UP or DOWN pad change the
timer’s setting one minute at a time. Pressing and
t/\
tflA 7T1D lTl/«f*A uiw WA AAJtVAWaawo UJI& ten minutes at a time. The timer can be set for a maximum of 24 hours. 3. Press the TIMER pad to start the timer. Ac the tirriAr r^rttinic rfnwn 4 4M« V* My V *« W beeps when one minute is left. After these beeps, the display will count down in seconds. When time nins io Change or Cancel the Timer Setting When ihe timer is counting down, use the UP and the TIMER pad to stop the timer Tlie timer cannot be cancelled until “SETTIME” di.sappears from To Display the Clock While the Timer Is Operating Pressing the CLOCK pad while the timer is operating display will change to show ihc clock, but the timer display back to show the timer. 49 -S 33 H C^cs:iJ
out, a signal will sound. Press the TIMER pad to stop
the signal.
DOWN pad to change the remaining lime, or press
tlic iiispiay.
will not inicrfcrc witli the timer’s operation: the
will continue to count down and will still signal when
iiinc is up. Press the TIMER pad again to change the