Before using your refrigerator, Cleaning your refrigerator, Removing packaging materiais – Whirlpool 3ET16NKXDG00 User Manual
Page 7: Plugging it in
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Before Using Your
Refrigerator
It is inr^rtant to prepare your refrigerator for use. This section tells you how to clean K,
connect it to a power source, install it, and level it.
Cleaning your refrigerator
Removing packaging materiais
Remove tape and any inside labels (except
the nxxlel and serial number Icibel) before
using the refrigerator.
To remove any remaining giue:
• Rub briskly with thumb to make a ball, then
remove.
OR
• Soak area with liquid hand-dishwashing
detergent before removing glue as de
scribed above. Do not use sharp instru
ments, rubbing alcohol, flammable fluids,
or abrasive cleaners. These can damage
the material. See “Important Safety
Instructions” on page 3.
NOTE: Do not remove any permanent
instruction labels inside your refrigerator. Do
not remove the Tech Sheet fastened under
the refrigerator at the front.
Cieaning it before use
After removing all packaging materials,
clean your refrigerator before using it, if
necessary. See cleaning instructions on
pages 22-23.
Plugging it in
Recommended Grounding Method
A 115 Volt/60 Hz (Plug 1), 220/240 Voh/50
Hz (Plug 2), or 220 Volt/60 Hz (Plug 3) AC
only 15 or 20 ampere fused and properly
grounded electrical supply is requir^. It is
recommended that a separate circuit serving
only this appliance be provided. Use a
receptacle which cannot be turned off with a
switch or pull chain. Do not use an extension
cord.
Plug 1
Plugs