Whirlpool 3ET16NKXDG00 - Manual (Page 18)

Removing the pull-out freezer floor
(on some models)
The freezer floor pulls out for easier access to
foods in the back of the freezer and for easier
cleaning.
To remove the freezer floor:
1. Lift both back 100008 ’ up and out.
2. Pull floor out about 1 inch (2.5 cm) with one
hand around the air tower section (center
back) and one hand at center front.
3. Lift floor up at rear until hooks release from
cabinet.
4. Pull floor out the rest of the way.
To replace the freezer floor:
1. Position back of floor into freezer opening.
2. Slide floor straight in until hooks drop into
place at rear of cabinet.
3. Replace lences” by aligning pins with
sockets in the floor. Push down until they
snap into place.
Using the ice cube trays
If cubes are not used, they may shrink. The
moving cold air starts a slow evaporation.
The longer you store cubes, the snnaller
they get.
To remove ice:
1. Hold tray at both ends.
2. Twist slightly.
17