Braeburn 1200NC - Manual (Page 6)

Factory Setting
Switch Default Options Comments
5
Heat Pump Systems
(cont.)
NOTES - Heat Pump Systems
[1] If batteries are installed the 24 Volt AC common connection is optional.
[2] Select O for cool active or B for heat active.
[3] Install a field supplied jumper between the W2 and E terminals if
there is no separate emergency heat relay installed.
Provide disconnect and overload protection as required.
NORM / HP NORM
F / C F
HE / HG HG
Set Installer Switches 4
NORM Select for conventional systems
HP
Select for heat pump systems
F Select for fahrenheit temperature scale
C Select for celsius temperature scale
HG Select for gas heat
HE Select for electric heat
Attach Thermostat to Sub-Base 5
1. Line up the thermostat body with the sub-base.
2. Carefully push the thermostat body against the sub-base until it snaps
into place.
NOTE: The reset button should be pressed after making any changes to the
installer switches.
NOTE: The thermostat
hinges from the top
and latches at
the bottom.