Avlink HX-2388 - Manual (Page 10)

Matrix Switching System—User Manual
9
5.0.2 Rear Panel
Figure 5-2 HX-2388 Rear Panel
The HX-2388 supports up to 8 input/output connectors (HDMI Type A or RJ-45) on the
rear panel, each female terminals form the signal input/output connectors. The HX-2388
signal input/output terminal channels are numbered from right to left as OUT1~4 / IN1~8
/ OUT5~8 channels. The input terminal channels supply you to connect to different
equipment including DVD players and graphics workstations. The output terminals can
be connected to projectors, video recorders, displays and multiplexes and so on.
ƒ Power Port: The Power Port is applicable for 100~240VAC, 50~60Hz connected to the
outlet of power source.
ƒ Power Switch: To switch power ON or OFF the HDMI matrix device.
ƒ RS-232: Use the RS-232 connection cable to connect the computer serial port (COM1
or COM2) to the RS232 communication port of the HDMI matrix device. The computer
can then be used to control the HDMI matrix after installation of application software.
The RS-232 port is a 9-pin female connector.
ƒ IR2: Connect to the IR BOX
.
ƒ Switcher:
- Pin1: Switch between RS-232 port and LAN port connection.
- Pin2: This Pin allows you to reset the IP value to 192.168.0.3. The steps are as
below:
a. Please adjust the pin2 down and re-start HX-2388.
b. After the HX-2388 re-starts about 10sec, shut down your equipment.
c. Adjust the pin2 up, then power on HX-2388 again.
d. The IP address will be restored to the default value: 192.168.0.3
- Pin3: No definition.
Pin # UP DOWN
1 LAN RS-232
2 NORMAL IP DEFAULT
3 NC NC