ALTANA LC 4 - Manual (Page 47)

BYK LC 4 What to do if...
47
6 What to do if...
Error message
0FL 0FL 0FL 0FL, UFL UFL UFL UFL
Error message
Err3 Err3 Err3 Err3
Error message
Err4 Err4 Err4 Err4
Error message
Err5 Err5 Err5 Err5
Cause Remedy
– The measured value lies outside
the measuring range
– Sensor module defective – Replace sensor module
Cause Remedy
– Erroneous calibration
– The data of the sensor module is
outside the specified characteris-
tics.
– Recalibrate
– Reset to default setting (see
section 4.12)
– Sensor module contaminated – Clean and replace sensor
module if necessary
– Moisture in the plug connection – Dry plug and socket
– Calibration solution not suitable – Check calibration solution
Cause Remedy
No sensor module – Connect sensor module
– Check the plug connection
– Switch the meter off and then on
again.
– Perform a processor reset (see
section 6.1)
– Replace sensor module
Cause Remedy
Sensor module defective
or
Wrong sensor module – Check the plug connection
– Switch the meter off and then on
again.
– Perform a processor reset (see
section 6.1)
– Replace sensor module