ALTANA LC 4 - Manual (Page 19)

BYK LC 4 Operation
19
4.3.3 Setting the TDS factor
1 If necessary, press < "_> [<Measured value>] repeatedly until the
measured parameter TDS is displayed (see section 4.3.2).
2 Using < ß> [<Temperature>], display the adjusted TDS factor.
3 Using < ß> [<TDS factor>], select the TDS factor.
The TDS factor flashes.
4 Using < <> or <>>, set the TDS factor (0.40 ... 1.00).
The measured TDS value display is always updated while doing so.
5 Confirm the TDS factor with < g>.
The TDS factor no longer flashes.
6 Using < ß> [<TDS factor>], display the measured temperature value.
MEM
CAL
C
mS/cm
RCL
CellTC
S
SAL O
2
TC
RESET
Cell
LAP
mbar
CAL
STO
LoBat Day.Month h:min min:s Ident Lap
8
CLR
Lin
Tref20 Tref20
M cm
k cm
Sal
1 cm
K
Tref25
nLF
ESC
3 1 4
1 0 8
TDS
mg/l
1