Setting up, 2. installing the scale – A&D Weighing FS-30Ki User Manual
Page 7
5
5. SETTING UP
5-1. Attaching a display pod to the display support column
1. Take out whole of the scale from the box
taking care not to pull the load cell cable.
2. Remove 2 clamps and 2 M4x12 screws.
3. Attach the display pod to the display
support column and tighten the
M4x12 screws removed at step 2.
4. Attach the clamps and tighten them
after tilting the display pod where
you like to use.
Put the excess part of the load cell
cable into the display support
column
5-2. Installing the scale
1. Select the place for installing the scale.
Refer to “Cautions for installing the scale”
below.
2. Adjust the level of the base, using the spirit
level and leveling feet. There is an extra
foot under the display support column.
Adjust this foot to reach floor after adjusting
the level of the base.
3. Connect the main power cord to the outlet that
has the earth wiring. You may use the earth
terminal on the rear side of the display pod
to ground the scale.
4. If necessary, adjust the viewing angle of the
display by loosening the 2 clamps, changing
the angle and re-tightening the clamps.
Clamp
M4x12 screws
Clamp
Display pod
Spirit
level
Leveling foot
Clamps
Earth
terminal
Earth
terminal
Column
support foot