A&D Weighing FS-30Ki - Manual (Page 11)

9
PRINT / ENT Key
The PRINT key is used when the serial data option OP-03
or OP-04 is installed and sends one data string. In the data
entry sequence this key is used to ENTER the numeric data
into the scale memory.
UNITS / 1 Key
The UNITS key is used to select the desired weighing unit .
In the data entry sequence this key displays the number 1.
STORE / 4 Key
The STORE key is used to store target weight and/or
HI/LO limits. In the data entry sequence this key displays the
number 4.
DISP. / 3 Key
When the DISP. key is pressed the analog weight display
steps through the 4 available modes of simple weighing, target
weighing, limit check weighing and display off. In the data
entry sequence this key displays the number 3.
C Key
The C key is used to clear an incorrect data entry from the
numeric keys.
0 and 2 Keys
These keys are used to display the number 0 or 2 during a
data entry sequence.