Holtgreven USED OCS-B 40,000 lb (x 20) - Manual (Page 19)

OCS User Guide
Page 16 of 24
Action
To check scale’s battery power, press and on remote controller in turn.
Function
System checks the battery, and feedbacks with battery’s left charge.
The screen flashes the battery charge in voltage, like the below 6.42V.
Please flip to 7 Battery section for more information about battery.
Condition
;
The scale must not be in H OLD mode. Otherwise, error message will keep
flashing.
System Setup
Action
To enter S YSTEM S ETUP M ODE , press 2ND and HOLD button on scale or and on
remote controller in turn.
To input digits, press ZERO and TARE button on scale or and on remote
controller.
To confirm the password or input value, press HOLD button on scale or on remote
controller.
To save and exit S YSTEM S ETUP M ODE , press 2ND button on scale for on remote
controller.
To exit S YSTEM S ETUP M ODE without saving, press ON/OFF button on scale or on
remote controller.
To learn how to input digits or change the option, please refer to 5 User Input section.
Function
In S YSTEM S ETUP M ODE , user can change the scale’s system function to their desired state,
like higher resolution, automatic power‐off delay, idle delay, the screen’s brightness, display
frequency, and anti‐motion level etc.
The screen displays the welcome message as below.
Condition
;
The scale must not be in H OLD mode. Otherwise, error message will keep
flashing.
Resolution
S YSTEM S ETUP
R ESOLUTION