Holtgreven USED OCS-B 40,000 lb (x 20) - Manual (Page 17)

OCS User Guide
Page 14 of 24
;
The scale must not be in H OLD mode. Otherwise, error message will keep
flashing.
;
The scale must be in G ROSS M ODE . Otherwise, error message will flash.
Please flip to System Unit of Scale Configuration in 6 Advanced Operation section in
Technical Manual for more information about scale’s measurement system.
Tare Set
Action
Press 2ND button on scale or on remote controller, and TARE button on scale or
on remote controller in turn (when the scale is in gross mode), to enter T ARE S ET function.
Press ZERO and TARE button on scale or and on remote controller to input the
digits.
Press HOLD button on scale or on remote controller to confirm the input value.
Function
The scale stores the tare weight that user inputs, and shifts to N ET M ODE . All subsequent
readings are deviations from the tare value.
The screen displays “00000” (or “0000.0” or “000.00”, depending on the resolution) with
the first “0” flashing, waiting for user’s input.
To learn how to input digits, please refer to 5 User Input section.
Condition
;
The scale must not be in H OLD mode. Otherwise, error message will keep
flashing.
;
The scale must be in G ROSS M ODE . Otherwise, error message will flash.
;
The input tare weight must be greater than 0 (or 0.0 or 0.00, depending on the resolution).
Otherwise, error message will flash.
;
The input tare weight must be lesser than scale’s maximum capacity. Otherwise, error
message will flash.
T ARE S ET
NOTICE:
Tare setting will reduce the apparent overloading range of the scale.
For example, if a 1000kg is set by tare set function, and the scale
maximum capacity is 5000kg, the scale will overload at a new weight of
4009kg (5000 – 1000 + additional 9 divisions).
NOTICE:
D ISPLAY U NIT S WITCH function only changes the unitScale does not save
this setting unless S YSTEM U NIT is changed.