Installing the module i/o connector, About the module i/o connector, Installing the module i/o connector -4 – Hardy HI 1769-2WS User Manual
Page 22: About the module i/o connector -4, Connector in locked position3-4
HI 1769-WS/HI 1769-2WS WEIGH SCALE MODULE
3-4
Step 3.
Gently slide the HI 1769-WS or HI 1769-
2WS module onto the other module. In our
example we connected two Hardy HI
1769-WS Weigh Modules.
Step 4.
When you have the modules aligned, press
Lever B towards Module A to fasten the
connector to Module A. (See Fig. 3-3)
FIG. 3-3 CONNECTOR IN LOCKED POSITION
Step 5.
The installation is comple.
Installing the Module
I/O Connector
About the Module
I/O Connector
The I/O Connector at the front of the module connects
the module to the Remote Terminal Assembly (-
RTA), a load sensor, or the HI 215IT Series Junction
Box depending on how many load sensors are
installed in the weighing system. See below for the
pin-out diagram. The pin-out diagram is located on
the inside of the module door. (See Fig. 3-4)