Doepfer A-190-4 MIDI/USB-CV/Gate/Sync Interface - Manual (Page 16)

USB/Midi-to-CV/Gate A-190-4 System A-100 DOEPFER
16
4.3.6 INITIALISE Function InI
You may want to erase all your parameter settings and
reset the values back to their defaults. If so, please use
the Initialise function.
Please navigate to the Initialise function with the ”>/+“ and
”” buttons.
• Hit ”
”. The display shows no The ”>/+“ button
flashes.
• Hit “
“ again or ” 2 “ to cancel the Initialise
function.
• Hit ”>/+“ to initialise all parameter settings to the
values shown in the following chart.
To confirm the store function, the display shows YES
for a short moment.
The following chart shows the initial parameter values:
Parameter Value Notes
CHANNEL 1 MIDI channel #1
REF. NOTE 24 #24 / Note C2
CLOCK TIME 1 clock frequency at clock output
= MIDI clock frequency
CLOCK POLARITY PoS positive
RETRIGGER 0 legato - ie. no retrigger
LFO FREQ. 006
LFO AMPL. 0 LFO off
PORTAMENTO 0 no portamento
BEND WIDTH 12 1 semitone
ASSIGN CV2 vEI velocity
ASSIGN MODE Hig highest note
GATE POLARITY PoS positive
RTRIG. TIME 0 off
CV CHAR. U-O 1 V / octave