COP-USA ASH56NVIR-36S - Manual (Page 30)

26
Chapter IV installation of pan/tilt
4.1 Safety measures
4.1.1 Qualification of installation or maintenance workers
¾ Submission of qualification certificate for CCTV system install or maintenance, and
qualification certificates for relevant works (such as high altitude operations etc),
these workers must have the following elementary knowledge and skills;
¾ Elementary knowledge for CCTV system and components and skills for installing;
¾ Elementary knowledge for LV wiring and LV electronic circuit wiring and operating
skills;
¾ Able to read and understand this manual.
4.1.2 Requirements for lifting equipment
¾ Using the safe lifting equipment suitable for site conditions and pan/tilt mounting
mode;
¾ The lifting equipment must have the enough lifting height for reaching the specified
position for installing purpose;
¾ The lifting equipment must have the excellent safety performances.
4.2 Warnings
¾ Forbid to install and operate this product at the dangerous area for storing or using
the flammables or explosives.
¾ During the installation and operation of this product, strictly obey all national and
local electrical safety codes.
¾ Confirm that the nearby touchable fixtures and this product have been powered off.
¾ The applicable voltage of this product is DC12V (on-board), AC24V (general
pan/tilt), strictly forbid to apply the voltage higher than the required directly upon
this product.
¾ This product is forbidden to install at the place beyond the specified service
conditions.
¾ In this manual, the DC12V(on-board), and AC24V(general pan/tilt) cables are
generally called the power cable, and RS485 cables are briefly called the
communication cable, and BNC video coaxial cables are briefly called the video