Checkline MESURgauge - Manual (Page 9)

User’s Guide
Load
Set a load threshold to begin the test (The load units are as
specified in the Select Units drop-down list box in the up-
per right area of this tab).
Travel
Set a travel threshold to begin the test. The second COM
port must be enabled for this selection to be made (the
travel units are as specified with the Inches / Millimeter
option buttons in the right-center area of this tab).
3.2 Stop Condition
Select an option button for time, load, the number of readings, or
travel to stop the test.
Time – Seconds
Set the duration of the test, in seconds.
Load – Threshold
Set the load threshold at which to terminate the test (the
load units are as specified in the Select Units drop-down
list box in the upper right area of this tab). See Stop
Threshold Options below for various load stop threshold
options.
Number of Readings – Readings
Set the number of readings at which to terminate the test.
Travel
Set the travel threshold to end the test. The second COM
port must be enabled for this selection to be made (the
travel units are as specified with the Inches / Millimeter
option buttons in the right-center area of this tab).
3.3 Load Stop Condition
Four test stop options based on load threshold are available:
Rising Edge
Stop threshold is higher than the start threshold (increasing
load).
8