Checkline MLT - Manual (Page 6)

22
Switching the MLT WESCO off
Press the rotary knob (4) for approx. 2 seconds.
"OFF" is shown on the display.
The MLT WESCO is switched off.
NOTE!
The MLT WESCO is automatically switched off
after approx. 5 minutes of disuse.
NOTE!
The MLT WESCO is automatically switched
off after approx. 15 minutes of a continuous
measuring process.
Settings
Switching the MLT WESCO on
Switch the MLT WESCO on by a short press of the
rotary knob (4).
The previously set measuring mode, e.g. "YARN
LENGTH", is shown on the display.
"MEASURE"
lashes on the display.
Initial Commissioning of the MLT
WESCO
For measuring yarn lengths, the MLT WESCO can both
be set to a metrical length unit (m/min) as well as to an
English length unit (yd/min).
m/min oder yd/min auswählen
Switch the MLT WESCO on by pressing the rotary
knob for at least 2 seconds.
The software version is shortly shown on the display.
Then, "SET mode" is displayed.
"m/min m" or "yd/min inch"
lashes on the display.
Select the desired "m/min m" or "yd/min inch" setting
by turning the rotary knob to the left or the right.
Conirm your selection by a short press of the rotary
knob.
i
i