Checkline MST - Manual (Page 7)

7
Have you read and understood the Operating Instructions, in particular
Chapter 1 “Basic Safety Notices”? You are not permitted to operate the
instrument before doing so.
Before working with the instrument you must put on your personal protective
clothing, if necessary. For example, eye protectors, gloves, etc.
To avoid damage, do not move the center roller by hand.
Tensions that exceed the tension range of the instrument by more than 100%
may cause permanent damage to the measuring spring and must be avoided
under any circumstances.
The ID plate with the CE mark and the serial number as well as the calibration
label (optional) and the SCHMIDT Quality Seal are provided at the bottom of
the instrument.
ET2-CA: Connecting cable for analog signal
ET2-CC: Digital connecting cable
ET2-P1: “TENSION INSPECT”
Software (Win 95 or higher) for viewing and storing the measured data
on a PC.
2.3 Optional Accessories
Tension meter with 9 V long life battery
1 AC adapter 12 V, 500 mA
1 Pair of scissors
1 Screw driver (1.5 mm blade width)
1 Operating Instructions
1 Stand
2.4 Delivery Includes
2.5 Unpacking
Unpack the tension meter and inspect it for any shipping damage. Notices of defect must
be filed immediately, at the latest within 10 days on receipt of the goods.
2.3.1 Pin Assignment of the Analog Cable (Option ET2-CA)
Pin 9 = analog signal
Pin 5 = Ground (GND)
9-pin male D-sub connector
3 Notices before Starting Measurement