Checkline MST - Manual (Page 20)

20
4.1 WINDOWS Terminal Program
The measured values and the mem-
ory contents can be transmitted over
the RS-232 interface to a personal
computer. You can connect the com-
puter to the connector of the MST
by using the ET2-CC special cable
which is available as an accessory.
The pin assignment of the connector
is described in Chapter 2.2.
Requirement:
A communication program, such as
Terminal or HyperTerminal (provided
on MS Windows Version 3.0 or later)
must be installed and configured on
the computer.
4 PC Communication (RS-232-C Interface)
4.2 TENSION INSPECT ET2-P1
SCHMIDT software (Win 95 or higher) for viewing and storing the measured data on a PC
(optionally available).
Commands for communication with a PC (polling)
ASCII
Code
Function Description
D
Continuous
transmission
Continuous trans-
mission of read-
ings.
Press any key to
stop transmission.
d Send
Transmit current
reading to PC
once.
m Save
Start logging of
measured data.
Stop data logging.
r Output
Output the memory
contents to the PC.
c
Clear
memory
Delete the memory
contents.
a
Damping
ON / OFF
Switch damping on
or off.
z Zero
Carry out zero
adjustment of the
instrument.