Checkline 6000TCX Series - Manual (Page 20)

21
Returning for Service Returning for Service
Before returning the Gage for service…
1.Install new batteries in the proper alignment.
2.Examine the probe tip for dirt or damage. The probe should
move up and down freely.
3.Perform a Gage Reset (pg.16).
4.Place a plastic shim onto bare metal (steel or non-steel,
depending upon whether you have an "F" or "N" probe) and
attempt a measurement.
If you must return the Gage for service, describe the problem fully
and include measurement results, if any. Be sure to also include
the Gage, probe, your company name, company contact, tele-
phone number and fax number or email address.
Website: www.defelsko.com/support
Troubleshooting Troubleshooting
Some common reports received by our Service Department along
with possible causes are located on our website. Most conditions
however can be cleared with a Reset (pg.16).
Available Options Available Options
A variety of accessories are available to help you get the most
from your PosiTector 6000 coating thickness gage.
W
W