Checkline FGS-220VC - Manual (Page 9)

- 4 -
4.2. Connection of force gauge to the stand
The connection and confirmation between FGS-VC and a force gauge is the following procedure.
If the connection is wrong, check:
Are the parameter settings of the force gauge correct?
Is the sequence of power on correct?
Is the cable correct?
If no problem, please contact our technical support.
Parameter setting of the force gauge
Set the following parameters.
Measurement polarity: +
RS232C baud rate: 19,200 bps
Refer to the manual of the force gauge.
Connect to FGS-VC
Connect the force gauge to FGS-VC by the
attached cable.
Power on
Turn on the power of the force gauge.
Next, turn on FGS-VC with the power switch on
the back.
Confirmation of the connection
Display of FGS-VC as follows:
1. Indicates "FGS-220VC".
2. Indicates "MANU"(Manual Mode)
If the connection is wrong,
2. Indicate "NO FORCE GAUGE" in 3 seconds, then
indicate "MANU".
55
22
22