Checkline FGS-220VC - Manual (Page 4)

Attention Safety
Warning
Disconnect from the AC outlet during any maintenance of the stand. Also, unplug when not
using for long periods of time.
May cause electric shock, a fire and injury.
Attention before using FGS-VC
Avoid the following.
Place where water, oil, or medicine may splash
Dusty locations
Places where condensation occurs
Places where explosive gases or ignition sources
are present.
Place where high vibration may occur
Places outside of operating temperature range.
32-104°F (0-40°C)
Cleaning with thinner and gasoline, etc.
Make sure the cable is not stuck in the stand.
Install the force gauge after turning off the power
switch.
Adjust the limit switches when the motor stops.
When digital force gauge FGV series is installed
Set "ovEr" in the F06 parameter, which is the parameter of Output Type.
If "ovEr" is not set, FGS-VC does not stop by the overload of the force gauge.
Confirm that the power supply is the
same voltage rating as the displayed
voltage rating on the unit
Do not plug AC connector with wet hand.
There is the possibility of electric shock.