Checkline FGS-220VC User Manual

Page 24

- 19 -

Parameter

The parameters are available while stopping.
Pressing SET button, the parameter setting starts.
The contents of the parameters setting is shown in the below flowchart.
Finally press SET button for saving.
If you want to cancel the setting, press ZERO button.

Condition setting

Force limit

The PUSH or PULL button can
be used to change.
The sign of force limit is changed
by MAX button alternately.

Repeat times

The UP or DOWN button of the
SPEED can be used to change.
The maximum value is 9999.
When the display is o and press

DOWN it will be 9999, and when

the display is 9999 and press UP
it will be 0.

SET

Moving direction
The parameter is the
direction of movement
from

“Start point” to

“Detect point”.
The STOP button can
be changed to Push or
Pull alternately.

Detect object
The force for detecting
object can be set by

PUSH or PULL button.

Speed

The parameter is the speed
setting for moving from "Start
point" to "Detect point".
The UP or DOWN button of the
SPEED can be used to change.

SET

Zero force

After

detecting

the

object, the stand moves
to opposite direction until
sensing the force less
than the setting force
data.
The PUSH or PULL
button can be used to
change.

Speed

The parameter is the speed
setting for moving from "Detect
point" to "Standard point".
The UP or DOWN button of the
SPEED can be changed.

Dwell timer

The parameter is the dwell timer
at "Standard point".
Pressing STOP, the dwell timer is
incremental.
When the dwell timer is 5s, it
returns to 0s pressing STOP.