Checkline FGS-220VC - Manual (Page 13)

- 8 -
5.3. Manual operation mode
The manual operation modes are MANU, JOG, SING and CONT.
The mode is selected by the measurement purpose and the usage.
5.3.1. MANU mode
This mode of operation is ideal for manually recording force measurements. The test stand will only operate
between the limits that are set by the test stand user. These are manually adjusted distance limits.
Contents
The test stand will move in the downward or upward direction when the respective PUSH or PULL button is
selected. The stand will continue to move in the selected direction until one of the following occurs: STOP
button is pushed, one of the limit stop switches is tripped or the emergency reset button is pushed.
MANU mode
When pressing the PUSH (PULL) key, FGS-VC goes to PUSH (PULL)
limit switch position.
FGS-VC stops if reaching the limit position.
JOG mode
This mode of operation is identical to MANU, except that the movement
in any direction will only occur while either the PUSH or PULL key is
depressed.
SING mode
Pressing PUSH or PULL keys, FGS-VC moves for one complete cycle
between mechanical distance limit stops.
CONT mode
Pressing PUSH or PULL keys, FGS-VC moves repeatedly up and down
between the mechanical distance limit stops.
Upper limit
Lower limit
PULL
PUSH
Stop with upper limit
switch ON
Stop with lower limit
switch ON