Checkline DT-361 - Manual (Page 23)

23
Reading out each setting value 4.5.2
This function is used to read out each setting value.
Reading out on internal oscillation emission 4.5.2.1
Press the “LOAD(SAVE)” key in the internal oscillation emission mode to read out the setting value.
Each press of the “LOAD(SAVE)” key changes the memory number to call.
Each press of the LOAD(SAVE) key changes the memory number in the order of 1->2->3->4->5-
>0 (free mode)->1->....
The memory number being read is indicated on the memory number display.
Operation Display
Each press of this
key
No memory number
(Free mode)
Memory number 1
Memory number 2
Memory number 5
* After reading out the setting value, when any of the setting values for the emission count (FPM),
emission angle (DUR) and/or delay time (PHA) are changed, the called memory number display goes
off, and it goes to free mode.