BUCHI Rotavapo R-215 - Manual (Page 40)

5 Putting into operation
40 R-210/215 Operation Manual, Version F
5 .9 Installing the vacuum controller
3
2
1
To install the vacuum controller on the
Rotavapor, proceed as follows:
• Screw the holder a for the vacuum controller
to the top of the Rotavapor.
• Slide the guide rail b of the vacuum controller
over the holder.
• Fix the vacuum controller to the holder by
tightening the wing nut c.
Fig. 5.12: Installing the vacuum controller
5 .10 Cable connections to the Rotavapor
4
1
2 3
a Mains connection
b Communication vacuum controller/Rotavapor c Communication vacuum pump/Rotavapor
d Communication vacuum controller/Rotavapor
Fig. 5.13: Cable connections to the Rotavapor
To make the electrical connections between the vacuum controller and the Rotavapor, proceed as
follows:
• Connect the power supply a of the Rotavapor to the mains.
• Connect the communication cable d of the vacuum controller to the Rotavapor b.
• Connect the communication cable c to the Vacuum Pump V-700/710.