Casio XJ XJ-360 - Manual (Page 26)

Troubleshooting
E-26
Troubleshooting
The status of the indicators lets you know the current
operational status of the projector. This section
provides details about indicators, and about the error
alert tones.
z “POWER” in the following table stands for the
“POWER/STANDBY” indicator.
Normal Operation Indicators
Error Indicators
z “ ” in the “Alert” column indicates that the projector will emit four long beeps when an error
occurs. “
U” in the “Alert” column indicates that the projector will emit two short beeps when
an error occurs.
z When an error occurs, wait until cool down is complete and the fan stops before unplugging
the AC power cord. If you unplug the AC power cord while the fan is still operating, an error
may occur when you plug the AC power cord back in.
z After you unplug the AC power cord, wait for at least 10 seconds before plugging the AC
power cord back in again.
Indicators and Alert Tones
When this indicator: Is this: It means this:
POWER : Amber steady
You have just plugged the AC power cord into a power
outlet. Wait until the projector enters the standby state
(see below) before trying to turn on power.
TEMP : Amber steady
LAMP : Amber steady
POWER : Amber steady
Standby state: The AC power cord is plugged in and
the projector is in standby.
POWER : Green flashing Projector is warming up after being turned on.
POWER : Green steady Projector is on and standing by for use.
POWER : Amber flashing
Projector is cooling down after being turned off. If the
projector is hot when you plug the AC power cord into
a power outlet, it also goes into a cool down state.
LAMP : Green steady Projector is in the low noise mode.
Indicator/Alert Description
POWER
TEMP
Alert
: Amber flashing
J
Red steady
: Red steady
:
An operational problem was caused by external noise or some
other factor. After confirming that the POWER/STANDBY
indicator is lit red (steady) and that the fan has stopped,
unplug the AC power cord. After the indicator goes out, plug
the AC power cord back in and turn on the projector again. If
the error occurs again when you turn power back on, contact
your original dealer or authorized CASIO Service Center.
POWER
TEMP
Alert : Red steady
: Red steady
: None Either of the following problems may be indicated when the
fan continues to run while the POWER/STANDBY and TEMP
indicators are lit red.
z The AC power cord was unplugged and then plugged back
in again too soon.
z An operation problem caused by external digital noise, etc.
Don’t do anything for about 90 seconds. After that, unplug the
AC power cord from the projector. After the indicators go out,
wait for at least 10 seconds. Next, reconnect the power cord
and turn power back on again. If the same error occurs
again, contact your original dealer or authorized CASIO
Service Center.
TEMP indicator
POWER/STANDBY indicator
LAMP indicator