Casio XJ XJ-360 - Manual (Page 16)

Getting Ready
E-16
z The RGB input terminal can be connected to the component video terminal of video
equipment using an optionally available component video cable (YK-3). For more information,
see “Connecting to a Component Video Output Device” in the User’s Guide
(UsersGuide_English.pdf) on the CD-ROM that comes with the projector.
Before performing any of the operations in this section, make sure you first set up the projector
and connect to an output device.
AC Power Cord Precautions
z Use the AC power cord that comes with the projector.
z Make sure that you use a power source with the same voltage as that specified for the projector.
z Do not share the outlet supplying power to the projector with other devices. If you are using
an extension cord, make sure that the ampere rating of the extension cord is compatible with
the power consumption value of this projector.
z Never use the power cord while it is still bundled together.
z Never place objects on top of the power cord and do not step on it.
z Never pull on the power cord. When unplugging it, grasp the plug.
z Use a conveniently located power outlet that you can reach easily when you need to unplug
the projector.
z If you need more information about the power supply, contact your original dealer or
authorized CASIO service center.
To turn on the projector
1.
Use the bundled AC power cord to plug the
projector into a power outlet.
z Plugging into a power outlet causes the three
indicators on the top of the projector to light
amber. After a short while, two of the indicators
will go out and only the POWER/STANDBY
indicator will remain lit amber, which indicates
the standby state.
z Note that the projector will not turn on if you
press the [ ] (power) key while all three
indicators are lit amber. Wait until the projector
is in the standby state before trying to turn it
on.
z This product is also designed for IT power distribution system with phase-to-phase voltage 230V.
2. Turn on the computer or video device that is connected to the projector.
3. If the projector’s lens cover is closed, open it.
4. After ensuring that the startup routine of the
computer is complete, press the projector’s
[
] (power) key.
z This causes the POWER/STANDBY indicator to
flash green, which indicates that the projector is
warming up.
Turning On the Projector
Bundled AC power
cord
Power supply connector
The shape of the
plug depends on
your geographical
area.
Input image projection