Aviom AN-16/i v.2 - Manual (Page 30)

22 AN-16/ i v .2 i Nput M odule u ser G uide
Adding Effects
Console insert points offer a convenient way to patch audio into the AN-16/i v.2 Input Module. But, there
are times when the insert send/return points will be needed for use with a DSP effect processor such as
a compressor. There are some optional ways of both getting audio into the AN-16/i v.2 and patching in
effects devices.
A-Net Audio Without the Effect
Connect the console insert Send to an input on the AN-16/i v.2. •
Connect the AN-16/i v.2 • t
hru
jack from the same channel as above to the input of the
effect processor.
Connect the output of the effect processor to the console’s insert Return jack.
•
The Send/Return loop on the console is complete. The audio sent thru the Aviom input module is not
processed by the effect device.
Console TRS
Channel Insert
Input Input Thru
Audio flows from the console insert point into the AN-16/i,
then into the effect device, and returns to the console
Output
AN-16/i v.2 Effect Device
Audio flows from the console insert point into the AN-16/i, then into the effect device, and returns to the console.
A patch bay may simplify this patching.
A-Net Audio With the Effect
Connect the console • insert Send to the input on the effect device.
Connect the output of the effect processor to an input on the AN-16/i v.2. •
Connect the Thru jack from the same channel as above to the console’s insert Return. •
Audio passing through the Aviom input module is heard with the effect processing.
Console TRS
Channel Insert
Input Input Thru
Audio flows from the console insert point into the effect device,
then into the AN-16/i , and returns to the console
Output
Effect Device AN-16/i v.2
Audio flows from the console insert point into the effect device, then into the AN-16/i, and returns to the console.