360 Systems MAXX-6T - Manual (Page 40)

____________________________________________________________________________________
Page 40 MAXX 6T Owner’s Manual
Programming GPIO Outputs
The MAXX 6T has six General Purpose Outputs, referred to as GPO 1 through GPO 6. Each GPO
can be programmed to go active on the selected channel when one of the following events occurs.
IDLE - Activate when the transport returns to idle
PAUSED - Activate when the transport is paused
STOPPED - Activate when the transport is stopped
PLAYING - Activate when the transport is playing
RECORDING - Activate when the transport is recording
RAID System Fault - Activate when a RAID or System Fault occurs
NO GENLOCK - Activate when there is no genlock
NO VIDEO INPUT - Activate when there is no video at the selected input
PLAYLIST - Control GPO via playlist. (Refer to Page 57)
To program a GPIO output, select EDIT->CONFIGURE->GPO. The screen of Figure 13 is
displayed. GPO 1 through 6 are the 6 triggerable outputs. The checkboxes to the right of each
selection represent channel 1, 2 and 3. GPO 5 is shown with the trigger option pulldown expanded.
To activate one of the GPO, pulldown the event menu and select which event will activate the
GPO. Select an associated channel where applicable by checking the channel checkbox. Click
APPLY to activate.
Figure 13 - GPO Configuration Screen