Panasonic OMNIVISION PV-8451 - Manual (Page 31)

:
VCR Plus+ Programming
Easy Taping.
l^^Check list before you begin.
O The clock is set.
n VCR Plus+ Setup is complete
(see pages 28-30).
1
4
7
8
•ADD/
DELETE
Use normal Timer Recording steps if:
• the PlusCode for a program is not listed.
• you anticipate the program, such as a sporting
event, to run over the scheduled stop time.
See page 19 to:
• cancel a timer recording in progress.
• replace program contents.
• review or clear program contents once set.
Important notes when using a DSS receiver
• When recording programs via a DSS receiver,
the DSS receiver must be left on.
• When recording programs via an antenna or
cable, the DSS receiver must be turned off.
1
Press PROG to display the
“SET PROGRAM” screen.
2
Press
AT
to select “VCR Plus+
PROGRAM,” and then press ►
to display the “VCR Plus+” screen.
----------SET PROGRAM-----------------
VCR Plust PROGRAM
TIMER PROGRAM
VCR PIUS+
ENTER PLUSCOOE NUMBER
/ I \
USING 0-9 KEYS
END : PROG KEY
3
Press the NUMBERED keys to
enter the PlusCode number.
• Refer to your local TV listings.
To Make Corrections
Press M repeatedly to delete the
VCR Rus+
ENTER PLUSCODE NUMBER
123456
USING 0-9 KEYS
BACKSPACE:4 KEY
ENTER :PR0G KEY
PlusCode number. Then, enter the correct number.
Press PROG to lock in your program.
5
Press the 1, 2 or 3 key to select
the program type.
6 Press AT and ► to select and
set each of the remaining items
as follows.
Remaining Items
• Category (N/A [not applicable], SPORTS,
“VIF
MOVIE, COMEDY, MUSIC, DRAMA)
• Speed (SP, LP. SLP)
1 ONE TIME
2 DAILY(MON-FRIJ
3 WEEKLY
TO SELECT PUSH 1.2 OR 3
DATE START STOP
TODAY
CATEGORY
:EIB
SELECT CATEGORY
To Make Corrections
Repeatedly press ► to move the cursor
to the right, or M to move to the left to the
incorrect entry and make the correction.
If you use connection type
“A" on page 28, the
channel shown in this on­
screen display wll always
be the cable box output
channel number.
7
Press PROG if contents are
acceptable.
To cancel program contents:
Press ADD/DELETE.
P DT START STOP
10AY 9:00Ai;
CH SPD
P
CANCELiADD/DLT KEY
SELECT 1-B:A ▼ KEY
ENTER :► KEY
END iPHOG KEY
8
Press PROG to complete
the program.
* If you're using a Cable Box, make sure
that it is tuned to the desired channel
and the power is left on for timer recording.
TURN VCR OFF
FOR TIMER RECORDING
AND
LEAVE CABLE BOX POWER ON
This display may differ depending
on your cable box hook-up.
0 Press POWER off to set the timer.
Multi Function Display
You can obtain unlisted PlusCode numbers by calling 1 - 900 - 454 - 7587. Call costs approximately $.95
per minute.
VCR PlusCodes can not be used to program the VCR to record DSS channels.
Avoid overlapping program times.
An on-screen display will indicate if an invalid PlusCode number has been entered or when all timer
programs are full.
31