Panasonic OMNIVISION PV-8451 - Manual (Page 12)

One Time VCR Setup
‘Important; If the remote control POWER, ACTION, PROG, CHA/V, INDEX or ADD/DLT button does
not work when pressed, press the VCR button on the remote and try the button again.
When the VCR is turned on for the first time,
it automatically enters the setup mode.
Setup includes the following:
• Choose the language for on-screen menus
and messages.
• Tell the VCR how your equipment is hooked up
{pages 6--9) so the VCR can correctly place
channels into memory.
• Get the VCR ready for dock set.
4
5
3
#
7
Using ► keys ^
Whenever a menu or program ^
screen is displayed, the PLAY, * “
STOP, REWIND, and FF buttons
on the remote control function
as ► only. For play, stop, rewind, and fast
fonward functions, use the buttons on the VCR.
To Set the Language, Channels
and Auto Clock
1
Turn the TV and VCR on.*
2
Tune your TV to the VCR output channel (the same
one you set on the back of the VCR: CH3 or CH4).
• If you used audio/video jack connection, tune the TV to its video input.
3
Press CH
A
for English
on-screen displays.
Or, press CH ▼ for Spanish
on-screen displays.
SELECT LANGUAGE
PUSH VCR CH A; ENGLISH
OPRIMin VCRCH TiESPAiiCH.
APP. VCR/TV : FRANQAIS
Or, press VCR/TV for French
on-screen displays.
• You can also set Uie language using the buttons on the VCR.
• If the wrong language is set, see the “Reset all VCR Memory
Functions" section on page 5.
• The VCR should be connected to an antenna or cable box
{page 6-9).
Press
AW
to select your hookup,
and then press ^ to set.
• If you selected “CABLE/DSS BOX ►
VCR ►TV," continue with step 5.
If not, go to step 7.
• If you are using the CABLE/DSS BOX^-
VCR^TV connection method, only the
cable box output channel will be placed in memory.
SELECT HOOKUP
CABLE/DSS BOX^VCFt^TV
VCRK;AflLE/DSS BOXhTV
VCRhTV
SELECT:* ▼ KEY
SET ;► KEY
END lACTION KEY
Press AT to select your cable
box or DSS receiver output
channel number, and then
press ► to enter.
• If necessary, refer to your cable
box manual.
* If you are using Audio/Video jack
connections to your cable box, select and
set “VIDEO OUT as the output channel.
SELECT HOOKUP
CABLE/DSS BO»VCRPTV
CABLE/DSS BOX OUTPUT CH
SELECT:* ▼ KEY
SET
; ► KEY
END : ACT ION KEY
Turn on the cable box and set it to the
PBS channel in your time zone.
• If you use a DSS receiver, it must be turned off.
7
Press CH
A
to start Channel
Auto Set and Clock Auto Set.
• The following messages appear:
“CH AUTO SET PROCEEDING"
“AUTO CLOCK SET PROCEEDING”
CHANNEL/CIOCK AUTO SET
CONNECT ANTENNA CABLE
AND IF YOU USE A CABLE
BOX. TUNE I T TO YOUR
LOCAL PBS CH THEN. . .
PLEASE PUSH CH UP KEY
or
\y
12
Case 1) Case 2)