Panasonic OMNIVISION PV-8451 - Manual (Page 29)

•Important: If the remote control POWER, ACTION, PROG, CHA/T, INDEX or ADD/DLT button does not
work when pressed, press the VCR button on the remote and try the button again.
If you are using a cable box and it is connected to your VCR in one of the ways shown in Connection Type A
on page 28, you will need to complete the Cable Box Setup steps below.
2
3
4
Cable Box Setup
Complete this page only if Type A
connection mothod (pg.28) is used.
1
Press ACTION* to display
the menu.
Press AT
to select “SET UP
CHANNEL,” and then press
► to display the “SET UP
CHANNEL” screen.
------------------ MENU ---------------------
SET UP VCR
SET UP FEATURE
SET CLCKK
SET UP CHAfJMEL
IDI ОМА/ LANGUE : ENGL I SH
SELECT:A ▼ KEY
SET :► KEY
END lACTION KEY ,
Press AT to select “CABLE/
DSS BOX SET UP.” and
then press ► to display the
“SELECT HOOKUP” screen.
------- SET UP CHANNEL
ANTENNA : CABLE
AUTO SET
CHANNEL CAPTION
CABLE/DSS 60X SET UF
VCR PIUS+ CH SET UP
SELECT:* ▼ KEY
SET :► KEY
END ; ACTION KEY
Press AT to select your hookup,
and then press ^
to set.
• If you selected CABLE/DSS BOX^
VCR^TV, continue vi/ith step 5.
If not, press ACTION three times
and turn to page 30.
SELECT HOnKUP
CABLE/DSS BOX»VCR>TV
VCH>CABLE/DS5 BOX^TV
VCR^TV
SELECT;* ▼ KEY
SET :► KEY
END :ACT ION KEY
Press AT
to select your cable
box or DSS receiver output
channel number, and then
press ► to enter.
• If necessary, refer to your cable
box manual.
• If you are using Audio/Video jack
connections to your cable box,
select and set “VIDEO OUT" as
the output channel.
SELECT HOOKUP
CABLE/DSS BOXPVCR*TV
CABLE/DSS BOX OUTPUT CH
ГЯПВИ
SELECT:* ▼ KEY
SET
:< *■ KEY
END : ACT I ON KEY
6
Press ACTION twice to end the setup and return
to the normal screen.
Go directly to “VCR Plus+ Programming” on page 31.
VCR PIUS+ and PlusCode are trademarks of
Gemstar Development Corporation. The VCR Plus+
system is manufactured under license from Gemstar
Development Corporation.
29