How to load recording paper, Problem solving – Panasonic UF-250 User Manual

Page 67

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

PROBLEM SOLVING

HOW TO LOAD RECORDING PAPER

Your facsimile machine uses a roll of special recording paper, which the

serviceman may load for you when the machine is installed. However, you can

easily load paper yourself by following the steps below.

1. Open the Receiver Cover Unit (Control Panel) by depressing the latch button.

2. If there is an old roll inside, lift it out and set a new roll in its place. Be sure

the direction of the roll is as shown below. Draw out more than 5 cm of

recording paper between the guide plates of the cutter section until it projects
outside the unit.