Panasonic GP-US532H - Manual (Page 15)

M CIRCLE Detection Area
/
n □ n
□ ■
■□□□□■I
innnnnni
L CIRCLE
{Large Circle)
/
Detection Area
/
"P
i
J
Note: Detection areas are not displayed on the
monitor.
3-1-1. Manual setting of the ELC detection control
area (MANU)
You can mask areas on the monitor screen to block the
strong brightness manually. Follow the steps below:
Notes:
The manual mask setting field is only displayed on
VIDE01, 2 and S-VIDEO OUT.
It is not displayed on RGB/SYNC output.
1. Move the cursor to the AREA parameter on the ELC
CONT menu.
2, Select MANU and press the PAGE button. The
manual mask setting field appears.
3. Select the area where backlight is bright by
or the ITEM button.
A. Press the PAGE button to mask that area. The-
mask turns white. (When the cursor is moved on an
area that has already been masked, the mask and
cursor start blinking.)
Masked Area
(WHITE)
/
7
)
Note: The area masked white will not be used in
the ELC detection.
5. Repeat the steps 3 and 4 to complete masking.
To cancel masking, move the cursor to that area
and press the PAGE button.
6. After masking is completed, press the PAGE button
for a second or more. The ELC CONT menu
appears.
3-1-2. Peak and Average Weight Control
(PEAK/AVE)
1. Move the cursor to the PEAK/AVE parameter. The
"I” cursor starts blinking.
** ELC CONT **
AREA ALL
PEAK/AVE P... II.
RET END
2. Move the “I" cursor to set the detection value.
When the “I" cursor is moved to the P (peak) side,
the peak value is detected.
When the “I" cursor is moved to the A (average)
side, the average value is detected.
-
13
-